loading surface
英 [ˈləʊdɪŋ ˈsɜːfɪs]
美 [ˈloʊdɪŋ ˈsɜːrfɪs]
网络 加载面; 负载面
双语例句
- Application of Space Loading and Surface Wave Technique in Bridge Pile Base Test Analysis
空间加载与面波技术在桥梁桩基试验分析中的应用 - Under continued loading the sliding surface is smoothed due to wear and compaction, which will result in a further decrease of the bond stress, similar to the case of plain bars.
在连续载荷下，因为磨损和压紧，该滑动面是光滑的，将导致粘结应力的进一步下降，类似于无节钢筋的情况。 - The hatchback is built in tailgate-style and can be opened in two steps: the area under the rear lights swings out like a pick-up loading surface and thus creates a lot of room for big items.
建立在tailgate-style掀背车，可于两个步骤：下的区域后方灯像一辆敞蓬波动，从而创造出装载表面很大的空间大的项目。 - First, we should construct a suitable Green's function, which is an essential solution of displacement field for an elastic half space with canyon with arbitrary shape impacted by anti-plane harmonic line source loading at horizontal surface.
首先，取含有任意形状凹陷的弹性半空间，在其水平表面上任意一点承受时间谐和的反平面线源荷载作用时的位移场作为Green函数。 - Formulas for the calculation of stresses in soil subjecting to distributed loading beneath the surface of the ground
竖向均布荷载作用在地基内部时的土中应力公式梯形分布条形荷载作用下土中附加应力的计算方法 - Loading on Influence Surface of Special Bridge
异形桥梁影响面动态规划加载 - Green Function in Elastic Half Space Impacted by Out-Place Harmonic Line Source Loading at Horizontal Surface
带凹陷的弹性半空间表面作用反平面简谐线源载荷时的Green函数 - This work make improvements to traditionally static high pressure method of measuring strength-radial pressure distribution with diamond anvil cell loading, including taking no gasket, straightly loading on the surface of sample with shell shape and in situ measuring thickness of sample under room temperature and high pressure.
对测量材料屈服强度的传统技术-DAC加载径向压力分布法做如下改进：不加封垫，以金刚石压砧直接加压于片状样品表面，室温高压下原位测量样品厚度。 - Program design of loading on influence surface
影响面加载程序设计 - Carrying out simulated analysis behavior of joint when monotonic loading on the top surface of column and beam, the stress distribution of concrete and steel tube and steel bar in joint zone and Concrete Filled Square Steel Tubular column were obtained.
模拟分析了对柱顶单调加载和对梁加载时的受力性能，得出了节点区和方钢管柱的混凝土、钢管、钢筋的应力分布。 - The damage state in various levels is described by the position at the interface among the loading surface, incipient damage surface and boundary surface in the energy releasing space.
在能量释放率空间内，由加载面与初始损伤面、边界面之间的位置描述损伤状态。 - In this paper, dynamic loading caused by the surface evenness was obtained by Quarter-truck vehicle model.
本文利用1／4模型求解了由路面不平整引起的动荷载。 - Under three-dimensional drainage condition, the consolidation of saturated cohesive soil is effected by the shape and size of the loading area on the surface.
在三向排水条件下，地基上荷载面积的形状和大小对地基固结速率是有影响的。 - Surface Instability of an Elastic Half Space of a Harmonic Material with Hydrostatic Loading on its Surface
表面承受常静水载荷的谐和弹性半无限体的表面不稳定性 - Loading on influence Surface& Influence Line of Bridge Structure
桥梁结构影响面加载及影响线加载 - The Critical Loading Surface of a Crack under Impact
裂纹在冲击载荷作用下起裂的临界载荷面 - The reasonable distribution law of wind loading on the surface of a building could be obtained, meanwhile the wind pressure of the big vestibule was analyzed.
给出了巨型建筑表面风压分布规律，同时对大门厅的内风压分布进行了分析。 - In calculating the stress and displacement on the loading surface, these singular integrals must be carefully solved.
在计算加载面上的位移和应力时应处理好奇异积分。 - Loading determination of surface driving screw pump
井口驱动螺杆泵泵载荷的确定方法 - The Stress and Strain Relation of Plasticity on the Corner of the Piece-Wise Linear Loading Surface under Isotropic Hardening
逐段线性加载面等向强化时角点处塑性应力应变关系 - The heat transfer efficiency and boiling hysteresis are affected by the method to change heat loading, the maximum initial heat loading, and surface aging before heating.
热负荷的改变方式、最高初始热负荷以及加热前表面状态均将显著影响T管的沸腾传热性能和滞后现象。 - The influence of loading type, surface state, structure of the screw root of tubing of rod-pumped well on fatigue strength of tubing is analyzed and the fatigue strength of the screw root of tubing is estimated.
分析了抽油机井油管的载荷形式、表面加工状态、特别是螺纹齿根结构特点对疲劳强度的影响，估算出了螺纹根部的疲劳强度； - After loading, the surface of metal-ceramic crowns displayed many shallow cracks, especially obvious after repeated firing crowns.
加载后金瓷冠表面均出现表浅裂纹密集等变化，尤其多次烧结组变化更明显。 - The addition of a small amount of Co, Cu and Fe oxides ( 1-2%) to OMS-2 was favorable for the catalytic combustion of ethyl acetate and toluene. However, due to excessive loading, the surface of OMS-2 was covered and the catalytic activity decreased.
添加少量的Co、Cu和Fe氧化物（1-2%）有利于提高OMS-2对甲苯和乙酸乙酯的催化燃烧活性，然而过多的负载量，造成OMS-2载体表面的覆盖使得活性反而下降。 - The effects of overloading, horizontal loading, surface layer thickness, surface layer modulus, base layer modulus and the interlayers contact to the shear stress at the interlayer between surface and base layers were analyzed.
分别针对超载现象、水平力影响、面层厚度、面层模量、基层模量以及层间接触情况等影响因素对粘结层所处位置的剪应力水平进行分析。 - The effects of different loading speeds and surface roughness have also been studied in the case of radial fretting.
考察了加载速度和表面粗糙度对径向微动运行行为的影响。 - BET results showed that after loading oxides the surface area of the metallic Ni catalysts increased.
BET结果表明，负载氧化物后Ni金属催化剂的比表面积大大增加。 - After the analyses of features of traffic loading, a new modified elasto-plastic model is proposed to describe the change pattern of accumulative deformation of soil under cyclic loading according to the concepts of yielding surface and loading surface.
论文分析了交通荷载的特性，根据屈服面和加载面的概念和循环荷载下土体的变形特征改进了土体经典的弹塑性模型，以反映循环荷载作用下土体变形逐步累计的变化规律。 - Modification by loading with macromolecular surface modifiers at very low content has a significant effect on the surface performance without affecting its ontology.
具有良好表面迁移、富集特性的大分子表面改性剂，可以在很低的加入量下起到明显的表面改性效果，且不影响其本体性能。 - Accumulative settlement on the loading surface is less than or equal to 0.32 mm after 2.3 million times of excitation.
230万次激振后，加载面累积沉降不大于0.32mm。